Internal Front exploded view
Remove the protector to access inside the module.
1. Untighten 4x M5x20 T25 torx head screw enough to remove the protector. Do not remove the screws completely. They have anti-loss washers.
2. Take care to protect the rib that compresses the gasket. 3. Assure the blue gasket remains in place on the body. 4. Place the protector on a safe surface to avoid scratches and dirt.
5. Access the interior of the module and mount the device on the gear plate. Machine the gear plate if necessary. 6. Complete all the wiring on the connector gear tray. 7. Before mounting the protector guarantee that the gasket is not damaged. That it’s clean and placed inside the groove to assure the IP 66 protection. Assure all the cabling is within the module and will not be caught between the protector and body. 8. Mount the protector and tighten the screws. The tighten torque is 3 N ⋅ m / 2.2 lb.ft.
9
DOC-0021067 revB
All rights reserved, © Schréder, 2022
Powered by FlippingBook