12. Complete all the wiring on the connector gear tray. 13. Before mounting the front protector, make sure that the gasket is well placed in the groove to provide IP66 protection. That it is clean and not damaged. 14. Assure all the cabling is within the module and will not be caught between the protector and body. 15. Mount the protector and tighten the screws. The tightening torque is 3 Nm. / 2.2 lb. ft. 16. Mount the clamps / cover.
External Back option module dimensions
Support bracket
19
DOC-0021067 revB
All rights reserved, © Schréder, 2022
Powered by FlippingBook