External Back how to install
1. Remove clamps / cover. 2. Remove the stainless-steel bracket, unscrew the 4x M5 x 12 T25 torx countersunk head screw. 3. If necessary to mount the device, machine stainless steel bracket. Take the necessary measures to protect the paint during the machining. 4. The feature cable into the body is hidden between the module body and the tube extruded. To ease the cable passage, the extruded tube can be removed. Untighten the two ST4.8 x 16 mm screws at the top of the tube extruded. 5. To do the wiring inside the module, remove the front protector. 6. Assure the blue gasket remains in place on the body. 7. The device cabling passes through the middle hole on the bracket. Assure that the cables have enough room and are not scraping against the bracket. With constant vibration, this could cut the cabling, damage the product, and cause electrical risks. If necessary, make the hole bigger or protect the hole with a grommet. 8. Pass the cable through the grommet on the body. 9. Mount the extruded tube.
10. Mount the feature on the bracket. 11. Mount the bracket on the body.
18
DOC-0021067 revB
All rights reserved, © Schréder, 2022
Powered by FlippingBook