D
D
D
B
L
B
Figure 1 Dimensions of foundation-hole for surface-mount poles
L
H
Figure 3 Dimensions of excavated hole for buried poles
Figure 4 Dimensions of drilled hole for buried poles using an auger
1.2. Buried GRP poles
Surface-mount poles comes in different lengths and the planting depth of the pole depends on the length and mounting height of the luminaire. Details pertaining to the excavation needed can be seen in the table below:
2 * LEDLUME-MAXI’s
Typical Head Weight and Wind Surface Area
2. Backfilling of buried poles The backfilling mix should have a composition of soilcrete 1:10, based on standard soil condition of 150kPa. Backfilling the pole hole should be done in layers of 250mm and compacted with a hand-rammer. The soil should be compacted evenly around the pole, and care should be taken that the pole does not lean to one side during compacting. Continue the backfill and compacting process until the hole is filled. If a stepped hole was used the same applies, and the entire hole must be filled and compacted.
Head weight: 13kg each Windage area: 0.045m 2 each
Pole Height (HT) (m)
MH (m)
D (m)
L&B (m)
H (m)
2.6
2.0
0.6
0.75
0.6
3.1
2.5
0.6
0.75
0.6
3.6
3.0
0.6
0.75
0.6
4.1
3.5
0.6
0.75
0.6
4.6
4.0
0.6
0.75
0.6
5.2
4.5
0.7
0.75
0.6
MH
5.7
5.0
0.7
0.75
0.6
Compact backfill in 250mm layers
6.3
5.5
0.8
0.75
0.6
HT
6.9
6.0
0.9
0.75
0.6
7.4
6.5
0.9
0.75
0.6
8.0
7.0
1.0
0.9
0.6
8.6
7.5
1.1
0.9
0.6
D
9.2
8.0
1.2
0.9
0.6
9.8
8.5
1.3
0.9
0.6
10.4
9.0
1.4
0.9
0.6
L/H
11.0
9.5
1.5
0.9
0.6
Figure 5 Backfilling and compacting the hole
11.6
10.0
1.6
0.9
0.6
D
13.4
11.5
1.9
0.9
0.6
14.0
12.0
2.0
0.9
0.6
Figure 2 Dimensions of buried poles
Table 2 Excavation dimensions for buried GRP poles
178
179
Powered by FlippingBook