Schréder Australia Pty Ltd Bldg 4A, Parklands Estate, 21-23 South Street, Rydalmere, NSW 2116, Australia T: 1300 489 780 | ABN 17 604 331 937 www.sylvania-schreder.com
BUILT-IN DRIVER TERMINAL BLOCK ORIENTATION ADJUSTMENT The terminal block on the BUILT-IN driver is able to be adjusted to a desired orientation by simply bending its mounting bracket. This adjustment should be ideally done before inserting the BUILT-IN driver in the pole. If cables are long enough, they can be terminated to the driver outside the pole. Make sure to secure the cables by inserting the cable ties provided through the holes in the end panel and then tighten around cables. 1. As supplied, terminals are flat against panel
As supplied, the terminals sit flat against the end panel (0°) which is ideal for horizontal mounting in cabinet racks. See Fig 1.
Fig 1
2. Wedge & Lift with Screw driver
To change the orientation simply wedge a screw driver between the bracket and panel and lever upwards a small amount. See Fig 2.
Fig 2
3. Complete adjustment using both hands
Once lifted a small amount, the final positioning can be done by gripping the bracket at the ends using both hands and pushing firmly upward. See Fig 3.
Fig 3
4. Final position, any angle to a maximum ∟90°
If mounting in a pole the driver must be hung vertically with terminals at the bottom and in this case, it may be most suitable to orient them at 90° to the end panel or at some other position between 0° and 90°. See Fig 4.
PAGE 7 OF 13
Document Version 2025-04
Rev: 2.3
Powered by FlippingBook