Schréder - BREEAM

HEA 06 ACCESSIBILITY

Schréder solution: uniformity & motion detection

2

Lighting plays an important role to ensure safe access to and from the building at all times. Our application engineers can propose the best combination of lumen packages and light distributions to ensure a high level of uniformity, preventing patches on the ground and therefore meeting the safety challenge. A motion detector can be added to the solution to ensure that the light increases gradually to create a safe environment when needed.

CREDITS

1

1

1

AIM

To recognise and encourage effective measures that promote safe and secure access to and from the building

ENE 02 ENERGY MONITORING

CRITERIA

Schréder solution: control system - OWLET & ABS

2

Safe access – max. 1 credit • The lighting for access roads, pedestrian routes and cycle lanes in accordance with the national best practices

Thanks to our control systems, the energy consumption of the lighting system can be closely monitored. Furthermore, they can use the same communication protocol as other services to be part of an overall integrated energy management plan (with lighting control and other building services). Customised reporting enables facility managers to track and continuously monitor energy costs and savings throughout the entire facility.

CREDITS

0

0

2

AIM

To recognise and encourage the installation of energy sub- metering that facilitates the monitoring of operational energy consumption

CRITERIA

Sub-metering of major energy-consuming systems – max. 1 credit • Where the total consumption of any single end-use category is more than 10% of the annual energy consumption for a given fuel type, it is necessary for this end-use to be sub-metered • Sub-metering of floors – max. 1 credit • In most circumstances, sub-metering should be per floor, or per floor plate where there are multiple service risers, cores, or floor plates

ENE 01 REDUCTION OF ENERGY USE AND CARBON

Schréder solution: energy efficiency

15

We are constantly developing new technologies to reduce the energy consumption of our luminaires. Furthermore our luminaires can be set to either dim or switch off entirely when no movement is detected after a specific period of time. These technologies ensure that energy is not wasted on lighting empty spaces, such as little-used storage areas.

CREDITS

2

2

2

AIM

ENE 03 EXTERNAL LIGHTING

Schréder solution : optimised outdoor spaces

1

To recognise and encourage buildings that minimise their operational energy consumption through efficient design

Because outdoor lighting is as important as indoor lighting, we also have solutions to illuminate outdoor areas like loading bays and car parks. We have a wide portfolio of solutions that can be deployed for all of your lighting needs. Those solutions are energy optimised and environmentally adaptive to minimise light pollution (CPLL).

CREDITS

0

1

1

CRITERIA

AIM

Defining the building energy performance using a building energy calculation software • Assessed building compared to notional equivalent • National building = local regulations or ASHRAE Standard (if local regulations are less rigorous) • Minimum 6 credits needed for excellent rating • Minimum 10 credits needed for outstanding rating Energy modelling study & qualified engineer required • Modelling software = National Calculation Methodology or BRE approved (country-specific) • Approved software: Designbuilder, TRNSYS, EPB-Software 3G

To recognise and encourage the specification of energy efficient light fittings for external areas

CRITERIA

• The average initial luminous efficacy of the external light fittings within the construction zone is not less than 60 luminaire lumens per circuit Watt • All external light fittings are automatically controlled to prevent constant lighting during daylight hours or in areas of intermittent pedestrian traffic

8

9

Powered by